How do I pair and set up my BoneSoundz Aware headphones?

Pairing your BoneSoundz Aware headphones with your phone, tablet, or computer is easy — and once it’s set up, it’ll reconnect automatically.

Step-by-Step Guide to First-Time Pairing

 Step 1: Power Off the Headset (if it’s on)

Before you begin, make sure your BoneSoundz Aware headset is completely turned off:

• If you hear music or see lights blinking, press and hold the power button until the device shuts down (you’ll hear a tone or feel a slight vibration).
• If you’re unsure, go ahead and hold the power button anyway — this won’t hurt anything.

---

 Step 2: Enter Bluetooth Pairing Mode

1. Press and hold the Power Button (located on the top of the right earpiece) for about 3–5 seconds.
2. Watch the LED light strip on the headset:
   • It should begin blinking red and blue back and forth.
   • This means your headset is now in Bluetooth pairing mode.

⚠️ Important: Don’t let go too early — just holding the button briefly will turn the headset on, but not into pairing mode. Keep holding until the light flashes red/blue.

---

 Step 3: Enable Bluetooth on Your Device

On the device you want to pair (like your phone or tablet):

1. Go to Settings
2. Tap Bluetooth
3. Make sure Bluetooth is turned ON

---

 Step 4: Connect to “BoneSoundz”

1. After a few seconds, your BoneSoundz headset will appear in the Bluetooth device list as "BoneSoundz"
2. Tap on “BoneSoundz” to pair
3. You’ll hear a voice confirmation through the headset saying “connected” or see confirmation on your screen

💡 If prompted to allow access to contacts or audio, you can safely approve this — it helps with call and media functions.

---

 What Happens Next?

• Once paired, your BoneSoundz Aware will automatically reconnect to the same device whenever it’s turned on and in range.
• You’ll only need to do this setup once per device.

---

 Want to Pair to a Different or Second Device?

BoneSoundz Aware supports multi-point pairing, which means it can stay connected to two Bluetooth devices at the same time. For example, your phone and laptop — you can listen to music on your computer and still answer calls from your phone.

How to Pair to a New Device:

1. Make sure the headset is not currently playing audio or actively connected
   • If it’s already paired to another device, disconnect or turn Bluetooth off on that device temporarily.
2. Enter pairing mode again:
   • Turn the headset off, then press and hold the power button until the red and blue lights flash again.
3. On your new device, go to Settings > Bluetooth, turn it on, and tap “BoneSoundz” when it appears in the list.

🔁 Once paired to both devices, the headset will switch automatically based on which one is playing audio or receiving a call.

---

🔧 Trouble Pairing?

If your device doesn’t see “BoneSoundz”:

• Make sure the headset is in pairing mode (flashing red/blue)
• Try turning Bluetooth off and back on on your phone
• Make sure the headset is not already connected to another device in range
• Try restarting your device, or using a different phone, tablet, or laptop for testing